Tilt-and-turn windows
Tilt-and-turn windows open two ways from one handle: tilted in at the top for ventilation, or swung in like a door for full opening and cleaning. They're standard in Europe and in most imported systems.
How it works
The handle has three positions. Pointing down, the window is locked. Turned sideways, the sash swings in on side hinges. Turned up, the sash tilts in from the top a few inches for secure ventilation.
Locking points around the whole sash pull it tight against the gaskets, which is why these windows seal so well. The hardware is usually from European makers such as Siegenia, Roto, Maco or G-U, and it adjusts at the hinges.
Common problems are a sash that drags at the bottom, a handle that won't turn, or a sash that comes out of its tilt position. These are almost always adjustments, not failures.
What we check on every install
- Hardware identificationWe identify the hardware brand so parts and adjustment specs are available.
- Sash adjustmentHeight and side adjustment at the hinges so the sash clears the frame.
- Locking pointsEvery keeper aligned so all locking points engage.
- Handle positionsChecked through closed, turn and tilt without binding.
- DrainageFrame drainage slots clear and facing out.
Questions we hear
The sash is hanging from one corner. Is it broken?
Usually the handle was moved while the sash was open, disengaging the top hinge arm. It can typically be re-engaged and adjusted.
Can tilt-and-turn windows be used as egress?
In the turn position they can, if the clear opening meets the requirement for that room.
Where do I get parts for an imported window?
Parts come from the hardware maker, not the window factory. We identify the hardware and source parts.
Related systems